All Categories
US$

Cart

Loadding...

How Deep Is the Mark?

Nov 19, 2026
WELDINGSTOPFIELD NOTES / 03
The gauge series · Surface depth

How deep
is the mark?

A small surface depression can be hard to judge by eye. This gauge turns it into a depth reading.

PIPE PIT GAUGE / IMPERIAL SCALE
WeldingStop pipe pit gauge with pivoting depth arm and inch scale
0–1/2″Depth range
1/64″Basic graduation
2 usesCorrosion pits + weld undercut

Find sound metal. Then find the low point.

The gauge compares the bottom of a local depression with the nearby surface. Its reference edge must sit on sound metal outside the defect while the measuring tip reaches the deepest point. The tables engraved on the body are quick references, not additional measurements.

Choose a check

Same gauge. Different surface.

Tap a card to follow the matching steps from the WeldingStop manual.
WeldingStop manual illustration of the pipe pit gauge positioned over a surface depressionMANUAL SETUP ILLUSTRATION
Measurement 01

Corrosion pit

  1. Place the gauge lengthwise along the pipe axis.
  2. Seat the reference edge on sound surfaces on both sides of the pit.
  3. Lower the arm until its tip reaches the deepest point.
  4. Hold the reference edge steady and read the depth with the tip in contact.
  5. Check several locations and record the maximum depth.

Across a curved pipe, the reference edge may sit unevenly. Follow the pipe axis; use a suitable straight reference bar if the surrounding surface is uneven.

Illustrative cooled fillet weld with a narrow undercut groove at its toeILLUSTRATIVE WELD-TOE PHOTO
Measurement 02

Weld undercut

  1. Seat the reference edge on sound base metal beside the weld.
  2. Position the tip directly over the groove at the weld toe.
  3. Lower the arm until the tip touches the deepest point.
  4. Keep the edge seated and read the depth while tip contact is maintained.
  5. Repeat along the weld and record the maximum depth.

This scene photo identifies the groove. Use the gauge and the manual steps for an actual measurement.

Where it earns its place

From a mark to a recorded depth.

The project’s inspection requirements determine what the reading means.
01 / PIPE SURFACE
Illustrative local corrosion pit on a steel pipe

Localized corrosion

Find sound metal around the pit before measuring its lowest point.

02 / WELD TOE
Illustrative undercut groove beside a weld

Undercut beside a weld

Reference the adjacent base metal, then trace the deepest part of the groove.

03 / MULTIPLE POINTS
Illustrative pipe inspection with several marked locations

Record the maximum

Measure more than one spot and retain the largest depth for review.

A number is a start.
The limit comes next.

Read the 0–1/2″ scale at the indicator, then compare the result with the drawing, inspection plan, or applicable procedure. The gauge records surface depth; it does not determine acceptance by itself.

Product, range, and method reference: WeldingStop Pipe Pit Gauge user manual, pp. 1–2. Product and setup images: WeldingStop. Scene photos are AI-generated illustrations; they are not measurement records.

>> Does the Weld Fit the Drawing?